For V Type
- 12 –
Set screw
Housing
Receiver flask
Ball joint clamp
Set screw
Caution
Be sure to raise the jack before
setting glass parts.
First raise the jack before setting glass parts. If
the jack is raised during setting work, a personal
injury may result.
Caution
Take care for condition and
handling of glass parts
Broken or flowed glass parts may result in accidents.
Inspect for damage or flows on the glass parts and
take care when handling them.
(1) Fix the condenser support bar into the hole at the back
of the unit using the set screw. (Adjust its position
after setting glass parts.)
(2) Allow the adopter to tightly contact against the
vacuum seal in the housing and then tighten with the
cap screw.
When you have tighten to some extent, re-tighten both
the cap screw and the adopter at the same time and
position the receiver flask so that its fixing opening
faces downward.
(3) Install the cooler to the adaptor.
(4) Install the cooler clamp.
Adjust the cooler support bar and the cooler positions
and fix with the set screw.
(5) Fix the receiver flask to the cooler with the ball
joint clamp.
(6) Fix the specimen flask to the rotary joint with the
Eyela clip.
(7) Gently insert the capillary into the adopter
(8) Install two coolant nozzles (gray), a vacuum nozzle
(white) and screw plug to the cooler.
Make sure that the nozzle packing sits in the groove
before installation.
(9) Follow the procedures above in the reversed order
to remove.
Cooler
Capillary feed tube
Coolant nozzle
（
gray
）
Vacuum nozzle (white)
Rotary joint
Eyela clip
Specimen flask
Nozzle set
Nozzle packing
Screw plug
Cooler clamp
Cooler support bar
Adopter
