- 11 –
(1) Allow the condenser to tightly touch the vacuum
seal in the housing and then tighten with the set
screw.
When you have tightened to some extent, re-
tighten both the set screw and the condenser at the
same time and position the receiver flask so that its
fixing opening faces down.
(2) Fix the receiver flask to the condenser with the
ball joint clamp.
For S type
Nozzle set
Nozzle packing
(3) Fix the sample flask to the rotary joint with the
Eyela clip.
(4) Gently insert the capillary into the condensers.
(5) Install two cooling nozzles (gray) and a vacuum
nozzle (white) to the condenser.
Make sure that the nozzle packing sits in the
groove before installation.
(6) Follow the procedures above in reverse order to
remove.
Condenser
Capillary feed
tube
Coolant nozzle
（
gray
）
Vacuum nozzle (white)
Set screw
Housing
Rotary joint
Eyela clip
Sample flask
Receiver flask
Ball joint clamp
4. Installing the cooler and a flask
If you want to use a glass trap ball, perform steps
in P.15 “8. Adjusting position for a glass trap ball”
before performing the following procedures.
Caution
Be sure to raise the jack before
setting glass parts.
First raise the jack before setting glass parts. If the
jack is raised during setting work, a personal injury
may result.
Caution
Take care for condition and
handling of glass parts
Broken or flowed glass parts may lead to accidents.
Inspect for damage or flows on the glass parts and
take care when handling them.
