Extron electronics MPX Plus 866 A, User Manual

Page: 35 / 222

3-5
MPX Plus 866 A Media Presentation Matrix Switcher • Operation
PRELIMINAR
Y
Control buttons
Primary functions
Action: Save changes Select Preset mode Select View mode Cancel/escape
Indication: Blinking : save needed Blinking : Save preset
Lit : Recall preset
View mode selected Flashes once
ENTER PRESET VIEW
ESC
Secondary functions
Port
configuration
Action 1:
Select Configuration mode
Action 2/
indication: Select 9600 baud.
Blinking : selected
Select 19200 baud.
Blinking : selected
Select 38400 baud.
Blinking : selected
Select 115200 baud.
Blinking : selected
Front panel
locks
Action: With Video and
Audio buttons, select
Lock mode 2 and/or
toggle between mode
0 and mode 2.
RGB delay Action: Computer video output group:
In Video mode,
decrease the
switching interval.
In Video mode,
increase the
switching interval.
Audio Action: In Audio mode,
decrease input level
or output volume.
In Audio mode,
increase input level
or output volume.
e
Enter button — The Enter button has one primary function (•) and three
secondary (
❏
) functions:
• Save configuration or preset changes that you make on the front panel
and indicate that a potential change has been created but not saved. To
create a simple configuration:

Specify video, audio, or both (see I/O selection buttons [ i ] and [ j ])

Press the desired input button (
a
or
b
)

Press the desired output button(s) ( c or d )

Press the Enter button.
N • Video outputs in the computer video group ( c ) can be tied only to a
computer video input ( a ).
• Video outputs in the low resolution video group ( d ) can be tied only to a
low resolution video input ( b ).
• Audio can be tied only to outputs 1 through 6. If you make a video and
audio tie from the low resolution video group (inputs 9 through 14), audio is
automatically tied to an output in the computer group (outputs 1 through 6).
❏
With the Preset, View, and Esc buttons, select Serial Port Selection and
Configuration mode. See “Selecting the RS-232 Primary port’s baud rate”
on page 3-42.
❏
Select 9600 baud for the rear panel RS-232 port in Serial Port Selection and
Configuration mode and indicate the selection. See “Selecting the RS-232
Primary port’s baud rate” on page 3-42.
❏
With the Video and Audio buttons, select front panel security
Lock mode 2 or toggle between mode 0 (unlocked) and mode 2. See
“Setting the front panel locks ( Executive modes)” on page 3-44.