MGP Pro Series • Installation
9
If desired, configure the LAN port by using SIS commands (see the LAN port setup
commands, beginning with the
Set IP address
command
in the
Command and
Response Table for IP SIS
commands on page 65) or by using the Comm./IP
Configuration menu on the front panel (see
Comm./IP Configuration Menu
on
page 28). The LAN port defaults are:
IP address:
192.168.254.254
Gateway IP address:
0.0.0.0
Subnet mask:
255.255.0.0
DHCP:
off
e
Reset button
— Pressing this recessed button causes various IP functions and
Ethernet connection settings to be reset to the factory defaults (see
Resetting
on
page 39 for more information).
f
Reset LED
— This LED, located to the upper-right of the reset button, blinks a varying
number of times to indicate which reset mode has been entered (see
Resetting
for
details).
g
BNC output connectors
— Plug an output device into these five BNC connectors, as
shown in figure 8.
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
RGBHV
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
RGBS
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
RGsB
R
/R-Y
G
/Y
B
/B-Y
H
/HV
V
HD YUV Component Video
Figure 8.
Connecting to BNC Output Connectors
h
HDMI output
— Plug an HDMI or DVI output device into this HDMI
connector.
NOTES:
•
When two output devices are attached (one to each output connector), they
both display the same image.
•
Connecting a DVI display to this HDMI connector requires an adapter cable.
LockIt brackets:
LockIt cable lacing brackets, one for each HDMI input and the output
connector, are provided with the MGP Pro. These brackets secure the HDMI cables to
the rear panel connectors and reduce stress on the connectors, preventing signal loss
due to loose cable connections. For information on attaching the LockIt brackets, see
the
LockIt HDMI Lacing Bracket Installation Guide
card, available at
www.extron.com
.
HDMI