MGP Pro Series • Operation
28
4.
Press the Next button to save the image as a bitmap (.bmp) file. The LCD screen
displays
[Detail]
=
Confirm
.
NOTE:
The unit supports 24-bit bitmap files only. Their file names must have no more
than 16 characters, including the .bmp extension.
ATTENTION:
The image that you save overwrites any existing image file with the same
file name.
5.
Press the Detail button (the top button located at the immediate left of the LCD screen).
The LCD screen displays
SAVE
BKGR
MEM
Saving
Busy!!!
The time the MGP Pro
takes to save an image varies depending on the image file size. For example, a
1024x768 pixel image takes about 150 seconds to save; a very large image combined
with a high output resolution could take as long as 5 minutes.
After 20 seconds, the MGP Pro displays the default cycle, but the Menu and Next
buttons continue to blink until the image capture is complete.
NOTE:
The unit continues to respond to commands while it is saving an image;
however, the response time is longer. It is not recommended that you attempt to
save or recall another background image during this process.
6.
If you want to recall a background file for the output display, press Next within
20 seconds.
Recalling a background from memory
To recall an image from memory for use as a background,
1.
Press Menu repeatedly until
BACKGROUND
CAPTURE
is displayed.
2.
Press Next repeatedly until
RECALL
BKGD
MEM
is displayed.
3.
Rotate either Adjust knob to select one of background image files to recall for use as
the output background.
To perform
no
action, press the Menu button.
4.
Press the Next button to recall the image. The LCD screen displays
Recalling
while
the image is being recalled, then
Recalled
after the recall is completed.
Comm./IP Configuration Menu
Use the Comm./IP Configuration menu to view and edit the serial communication port
configuration and the MGP Pro IP addresses. The Comm./IP Configuration menu consists
of two levels: view and edit.
Viewing serial port and IP settings
When you first reach the Comm./IP Configuration menu, the view level is displayed. At this
level, all the screens that you cycle through by pressing Next show the current settings. The
Adjust knobs are disabled and you cannot make changes from the screens.
To view the serial port and IP settings:
1.
Press Menu repeatedly until
COMM./IP
CONFIGURATION
is displayed.
2.
Press Next repeatedly to cycle through the screens displaying the current settings for
the serial port, MAC address, DHCP mode, IP address, Gateway address, and Subnet
mask.
3.
Press Menu to return to the Comm./IP Configuration screen.