IPCP 505 • Hardware Features and Installation
18
Resetting the Unit
There are five reset modes that are available by pressing the
Reset
button on the front panel. The
Reset
button is recessed, so use a
pointed stylus, ballpoint pen, or Extron Tweeker to access it. See the
on the next page for a summary of the modes.
ATTENTION:
•
Review the reset modes carefully. Using the wrong reset mode
may result in unintended loss of flash memory programming, port
reassignment, or an IPCP unit reboot.
•
Analysez minutieusement les différents modes de réinitialisation.
[voir tableau page suivante]. Appliquer le mauvais mode
de réinitialisation peut causer une perte inattendue de la
programmation de la mémoire flash, une reconfiguration des
ports ou une réinitialisation du processeur.
The reset modes (with the exception of Mode 2) close all open IP and Telnet connections
and close all sockets.
NOTE:
If you hold down the Reset button continuously, the LED blinks every 3 seconds,
and the unit enters a different mode, from Modes 3 through 5.
For Mode 5 (Reset to Factory Defaults) the LED blinks three times, the third blink
indicating the last mode. The modes are separate functions, not a continuation from
Mode 1 to Mode 5.
R
Power
LED
Reset
Button
