Extreme Networks Summit Summit24, Installation And User Manual

Page: 172 / 244

172 Summit24e3 Switch Installation and User Guide
IP Unicast Routing
To change the relative route priority, use the following command:
config iproute priority [rip | bootp | icmp | static | ospf-intra | ospf-inter |
ospf-as-external | ospf-extern1 | ospf-extern2] <priority>
Configuring IP Unicast Routing
This section describes the commands associated with configuring IP unicast routing on the switch. To
configure routing, follow these steps:
1 Create and configure two or more VLANs.
2 Assign each VLAN that will be using routing an IP address using the following command:
config vlan <name> ipaddress <ipaddress> {<mask>}
Ensure that each VLAN has a unique IP address.
3 Configure a default route using the following command:
config iproute add default <gateway> {<metric>}
Default routes are used when the router has no other dynamic or static route to the requested
destination.
4 Turn on IP routing for one or all VLANs using the following command:
enable ipforwarding {vlan <name>}
5 Turn on RIP or OSPF using one of the following commands:
enable rip
enable ospf
Verifying the IP Unicast Routing Configuration
Use the
show iproute
command to display the current configuration of IP unicast routing for the
switch, and for each VLAN. The
show iproute
command displays the currently configured routes, and
includes how each route was learned.
Additional verification commands include:
•
show iparp
— Displays the IP ARP table of the system.
•
show ipfdb
— Displays the hosts that have been transmitting or receiving packets, and the port and
VLAN for each host.
•
show ipconfig
— Displays configuration information for one or more VLANs.
IP Commands
Table 48 describes the commands used to configure basic IP settings.
BOOTP 5000
Table 47: Relative Route Priorities (continued)
Route Origin Priority