Extreme Networks Summit 300-48, Software User'S Manual

Page: 27 / 198

Common Commands
Summit 300-48 Switch Software User Guide 27
config sys-recovery-level [none | critical | all] Configures a recovery option for instances
where an exception occurs in
ExtremeWare. Specify one of the
following:
•
none
— Recovery without system
reboot.
•
critical
— ExtremeWare logs an
error to the syslog, and reboots the
system after critical exceptions.
•
all
— ExtremeWare logs an error to
the syslog, and reboots the system
after any exception.
The default setting is
none
.
config time <date> <time> Configures the system date and time. The
format is as follows:
mm/dd/yyyy hh:mm:ss
The time uses a 24-hour clock format. You
cannot set the year past 2036.
config timezone <gmt_offset> {autodst | noautodst} Configures the time zone information to
the configured offset from GMT time. The
format of
gmt_offset
is +/- minutes from
GMT time. Specify:
•
autodst
— Enables automatic
Daylight Savings Time change.
•
nosautodst
— Disables automatic
Daylight Savings Time change.
The default setting is
autodst
.
config vlan <name> ipaddress <ip_address>
{<mask>} Configures an IP address and subnet
mask for a VLAN.
create account [admin | user] <username>
{encrypted} {<password>} Creates a user account. This command is
available to admin-level users and to users
with RADIUS command authorization. The
username is between 1 and 32 characters,
the password is between 0 and 16
characters.
create vlan <name> Creates a VLAN.
delete account <username> Deletes a user account.
delete vlan <name> Deletes a VLAN.
disable bootp vlan [<name> | all] Disables BOOTP for one or more VLANs.
disable cli-config-logging Disables logging of CLI commands to the
Syslog.
disable clipaging Disables pausing of the screen display
when a show command output reaches
the end of the page.
disable idletimeouts Disables the timer that disconnects all
sessions. Once disabled, console sessions
remain open until the switch is rebooted or
you logoff. Telnet sessions remain open
until you close the Telnet client.
disable ports <portlist> Disables a port on the switch.
Table 6: Common Commands (continued)
Command Description