Extreme Networks Summit 300-48, Software User'S Manual

Page: 140 / 198

140 Summit 300-48 Switch Software User Guide
Status Monitoring and Statistics
—
ipaddress
— The IP address of the syslog host.
—
facility
— The syslog facility level for local use. Options include
local0
through
local7
.
—
priority
— Filters the log to display message with the selected priority or higher (more critical).
Priorities include (in order) critical, emergency, alert, error, warning, notice, info, and debug. If
not specified, only critical priority messages are sent to the syslog host.
NOTE
Refer to your UNIX documentation for more information about the syslog host facility.
Logging Configuration Changes
ExtremeWare allows you to record all configuration changes and their sources that are made using the
CLI by way of Telnet or the local console. The changes are logged to the system log. Each log entry
includes the user account name that performed the change and the source IP address of the client (if
Telnet was used). Configuration logging applies only to commands that result in a configuration
change. To enable configuration logging, use the following command:
enable cli-config-logging
To disable configuration logging, use the following command:
disable cli-config-logging
CLI configuration logging is enabled by default.
Logging Commands
The commands described in Table 51 allow you to configure logging options, reset logging options,
display the log, and clear the log.
Table 51: Logging Commands
Command Description
clear counters Clears all switch statistics and port counters.
clear log {static} Clears the log. If
static
is specified, the
critical log messages are also cleared.
config log display {<priority>} Configures the real-time log display. Options
include:
•
priority
— Filters the log to display
messages with the selected priority or
higher (more critical). Priorities include
critical, emergency, error, alert, warning,
notice, info, and debug. If not specified,
informational priority messages and higher
are displayed.