Extreme Flight Legacy Aviation Turbo Bushmaster, Manual

Page: 43 / 61

onto the rudder control horn, thread the cables thru the tubes in
the rear of the fuselage and then build the front end of the
cables on the servo side. To assemble the pull-pull linkage
follow these steps:
1. Slide one of the aluminum crimps onto the braided wire.
Insert the wire through the hole in the brass fitting and insert the
end of the wire back through the crimp. Loop the wire around
the crimp and insert again into the crimp. Carefully use a pair
of side cutters to crimp the wire in several places.
50. Follow this same method to assemble the linkages in the
forward part of the system that will attach to the servo arm. The
cables should cross in the fuselage for proper function. Adjust
43