Exsurco Medical Amalgatome SD, User Manual

Page: 33 / 62

A
MALGATOME
®
SD U
SER
G
UIDE
PN#: X101456, Rev. C Page 29 of 56
It is important when re-assembling the lock nut and locking knob back onto the handpiece the lock nut and
locking knob are placed in the proper order and orientation on the hand piece. Below is a closeup showing the
connection of the lock nut onto the wrench, and the locking knob onto the handpiece for ease in assembly:
Assemble lock nut onto wrench Place lock knob over top of lock nut on wrench, the “U” facing UP.
Slide wrench (with lock nut and lock knob on) over the pinion of handpiece to engage at base of handpiece and
screw on, finger tight, counter clockwise till secure. NOTE: the design on the handpiece should match the lock
knob, and when looking down onto the handpiece the bottom of the U should be facing out.
Automated Cleaning of the Reusable System
Please follow the exact same steps outlined above in steps 1-7 for automated cleaning. It is the same pre-cleaning
protocol for the components. When finished with step 7 above, stop (Do Not Follow Steps 8-10). Follow the
automated cycle parameters validated below:
NOTE: Load the Hand piece, open end facing down,
an angle (to allow for draining) into the washer-disinfector.