exonda RDC01, Manual

Page: 24 / 250

22 ENGLISH
1. Remove the screw at the cutting-length
lever 4 . Here, mind the 3 cup springs
positioned between screw and cutting-
length lever.
2. Remove the screw, the 3 cup springs and
the cutting-length lever 4 from the hair
clippers 6 .
3. Remove the smaller screw on the other
side.
4. Attach the cutting-length lever 4 on the
other side. Make sure that the small peg is
inserted into the matching recess.
5. Place the 3 cup springs on the longer
screw and mind the correct direction of
the curvature:
– 1.: curved towards the screw head:
)
– 2.: recessed towards the screw head:
(
– 3.: curved towards the screw head:
)
6. Fasten the cutting-length lever 4 by tight-
ening the longer screw.
7. Tighten the smaller screw on the other
side.
5 Operation
5.1 Connection to the power supply
DANGER! Risk of injury from cutting
~
The appliance must be switched off (rotary switch 3 in position 0 ),
before plugging the power unit 9 into a power socket.
• Insert the power unit 9 into a power socket corresponding to the
specifications of the type plate. The power socket should be easily
accessible at any time.
5.2 Switching on/off and adjusting speed
Use the rotary switch 3 to switch the hair clippers 6 at two speeds on
and off again.
• Turn the rotary switch
3 to one of the following positions:
• By selecting the speed (position I or II ) you adjust the hair clip-
pers 6 to your working method and to the hair structure of your
customer.
Item Function
0 turned off
I switched on , lower speed
II switched on , higher speed
__Exonda_Red_Deer_No1.book Seite 22 Montag, 10. September 2018 1:03 13