exonda RDC01, Manual

Page: 22 / 250

20 ENGLISH
~
Pull the power unit out of the power socket, …
– after every use,
– if there is a fault,
– when you are not using the appliance,
– before removing or attaching the cutter head,
– before you clean the appliance and
– during thunderstorms.
~
To avoid any hazard, do not make modifications to the appliance.
The connector cable cannot be replaced at home. Repairs must be
carried out by your authorised service centre.
~
Use only the original mains plug adapters.
~
Never attempt to remove dust or foreign bodies from inside the
appliance using a pointed object (e.g. with a tail comb).
DANGER! Risk of injury from cutting
~
Do not use the appliance with a damaged or fractured cutter head.
~
The cutter head must not be disassembled.
~
While the appliance is switched on, do not touch the cutter head.
~
The appliance must be switched off (rotary switch in position 0 ):
– before plugging the power unit into a power socket.
– when attaching or removing an attachment comb.
– when you put down the appliance, e.g. when you interrupt the
cutting process briefly.
~
Pull the power unit out of the power socket:
– when it is not supervised,
– before removing or attaching the cutter head,
– before you reset the cutting-length lever and
– before cleaning the appliance.
Ensure that the power unit cannot be plugged in again during the
activity.
~
Use only the original attachment combs.
~
Do not use a damaged attachment comb.
WARNING! Risk of material damage
~
The cutter head is a precision part. Protect it against damage.
~
In order to avoid increased wear of the cutter head and motor, the
cutter head must be cleaned and oiled regularly (see “Cleaning
and care” on page 23).
~
Do not use any sharp or abrasive cleaning agents.
~
Protect the appliance against heat (e.g. direct insolation), chemi-
cal substances (e.g. perm agents) and mechanical damage (e.g. by
dropping).
Specifications according to Machinery Directive 2006/42/EC
A-weighted emission sound pressure level at workstations at a
distance of 1 m, L
pA ≤ 70 dB(A)
measured maximum noise emission value, including uncertainty of
measurement according to EN ISO 4871. Determination of the values
according to EN 60704-2-9 with reference to EN 60704-1
Vibration total value to which the hand-arm system is subjected,
a
h
≤ 2.5 m/s 2
measured maximum vibration total value including uncertainty of meas-
urement. Determination of the values according to EN ISO 5349-1/2
__Exonda_Red_Deer_No1.book Seite 20 Montag, 10. September 2018 1:03 13