Setting Up DSL/IP Tests
50
MAX-630G
Test Configuration
G.INP
allows you to
Enable
/
Disable
the standards based Physical
Layer Retransmission scheme for impulse noise protection. This entry
applies only to Auto and Manual tests.
NAT
(network address translation) allows you to
Enable
/
Disable
the
translation of the IP addresses of computers in a local network to a
single IP address.
NAT
is available only if
Access Mode
is set to
DHCP
,
Static
, or
IPoA
.
Note:
For
Ethernet Test Setup
,
NAT
is available only for GVXAA and GVXAB
models.
Login to WAN (Data Test)
(in
Manual Test Setup
only) can be set to
one of the following, when running a
Manual Test
:
Auto
will start the WAN login automatically right after
Show Time
.
Manual
enables a
Login
button on the
WAN Status
page, once
Show Time
is reached. You must press the button to start the WAN
login.
This parameter can
not
be selected for the following
Access Modes
:
Sync Only
,
Bridged
, and
IPv6 (DHCP)
, and will be set to Auto.
The following parameters are available only when
Access Mode
is
PPPoE
or
PPPoA
.
Login Name
/
Password
is your user ID and password.
Obtain IP
is either
Dynamic
where the access concentrator or
broadband remote access server assigns a temporary IP address to
the unit, or
Static
where you enter the IP address of the unit.
Static IP
is the address of the current location assigned by the
service provider. This entry is available only if
Obtain IP
is set to
Static
.
