Controller & Transmitter Functions (cont’d)
AuXiLiARy FunCTiOnS 1-4
:
The actual operation of these functions will vary from car to car They are designed
to operate extra vehicle functions like automatic sliding doors or motorized hatches
Aux 1-4 are virtual outputs only available on certain vehicles when this system is
integrated with the vehicle’s data network. Consult with your installer to fi nd out if any
of these functions are available for your vehicle. If so, confi rm each operation with the
controller and write each function in the blank spaces provided below
-
Auxiliary 1 Function (___________________)
: To activate this function, press
and release the “
trunk
” and “
start
” buttons simultaneously)
-
Auxiliary 2 Function (___________________)
: To activate this function, press
and release the “
lock
” and “
trunk
” buttons simultaneously)
-
Auxiliary 3 Function (___________________)
: To activate this function, press
and release the “
unlock
” and “
start
” buttons simultaneously)
-
Auxiliary 4 Function (___________________)
: To activate this function, press
and release the “
unlock
” and “
trunk
” buttons simultaneously)
LOW BATTERy/LOW TEmP AuTOmATiC STARTinG
Other Remote Start Features
REmOTE VALET:
Press “LOCK” then “UNLOCK” then “TRUNK” +
“START” within 5 seconds
•
THE SYSTEM WILL ENTER VALET MODE
SEE PAGE 10 FOR MORE INFO ON VALET MODES
•
UPON RECEIVING CONFIRMATION FROM YOUR SYS-
TEM, THE CONTROLLER WILL SHOW THE VALET ICON
TO EXiT VALET ViA REmOTE, REPEAT ThESE STEPS
This feature will automatically start the engine if the vehicle battery drops below 11
volts or the interior temperature drops to 15 (or 32) degrees fahrenheit You must ac-
tivate these features each time you park your car to use them They can be activated
one of two ways:
method 1 - Valet Switch
• Turn the ignition switch “on”, then “off” (engine not running), and within 7 seconds
press the valet switch twice If there is a 2 second delay without additional valet but-
ton presses, the horn will honk 3 times activating low voltage start mode
• To activate low temp starting, enter low voltage start mode as described above
then, immediately after the horn honks, press the valet switch 1 time (15 degrees) or
2 times (32 degrees) within 5 seconds. The horn will honk to confi rm your selection.
method 2 - With The Controller (Low Volt + Low Temp - 15 Degrees Only)
• Within 5 seconds of pressing LOCK, press the START button. You will get one chirp
and the 2-way controller will alternate between “ARM” and “RS AUTO”
nOTE:
When low temp start mode is activated, low voltage start is also activated
These features will operate once every two hours until the ignition key is
turned “ON”
1
2
3
7
