Controller & Transmitter Functions (cont’d)
ChAnnEL 3:
Press and hold the “TRUNK” & “START“ buttons for 3
seconds
•
YOUR SYSTEM WILL ACTIVATE THE CHANNEL 3
OUTPUT
•
UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL SHOW “CH3” ON
THE CLOCK DISPLAY
ChAnnEL 4:
Press and hold the “LOCK” & “TRUNK” buttons for 3
seconds
•
YOUR SYSTEM WILL ACTIVATE THE CHANNEL 4
OUTPUT
•
THERE IS NO 2-WAY CONFIRMATION FOR THIS
FUNCTION
The engine will run for the preset run time (see user feature #1)
•
Run Time Extender
: Press the “START” button one time during remote start
to restart the engine run timer The timer will restart at “0:00”
nOTE: This can only be used once per remote start cycle. The controller will also give you
“run time expiration” warning (2 chirps) 1 minute before the remote start cycle ends.
•
If you decide not to drive your vehicle, you can turn off the remote start using
the same method to turn it on (Default = press “START” twice in 5 seconds)
nOTE: if user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so
an additional press is required.
•
Upon entering the vehicle during remote start mode, turn the ignition key to
the “ON/RUN” position (
nOT START!!
) When you press the brake pedal, the
remote start will turn off allowing the ignition key to take over
ChAnnEL 5:
Press and hold the “UNLOCK” & “START“ buttons for
3 seconds
•
YOUR SYSTEM WILL ACTIVATE THE CHANNEL 5
OUTPUT
•
THERE IS NO 2-WAY CONFIRMATION FOR THIS
FUNCTION
5
