Excalibur AL-1860-EDPB, Operation Manual

Page: 20 / 24

installer Programmable Features (cont’d)
Feature #5 - Light Relay Function
Dome Light Output (press “ lock ” button to program) - DEFAuLT
Start (press “ unlock ” button to program)
ignition Output (press “ trunk ” button to program)
Accessory Output (press “ start ” button to program)
Status
(press “
lock
” & “
unlock
” button to program)
The system has two built-in relays, which can be programmed to perform several different func-
tions The primary function of this relay, is to operate the vehicle’s dome, or interior lighting as
part of the system’s operations Optionally, if desired or needed, this relay can be programmed for
the other functions listed above
Feature #7 - Starter Cranking Time
0.75 Second (press “ lock ” button to program) - DEFAuLT
1.00 Second (press “ unlock ” button to program)
1.5 Seconds (press “ trunk ” button to program)
2.25 Seconds (press “ start ” button to program)
This feature determines the crank time of the 1st start attempt when in “Tachless” mode If the
engine doesn’t start on the first attempt, it will retry up to 3 more times extending the crank time by
an additional 02 second with each attempt
Feature #8 - Door Lock/unlock Outputs
0.8 Second Outputs (press “ lock ” button to program) - DEFAuLT
3 Second Outputs (press “ unlock ” button to program)
Double Pulse unlock Output (press “ trunk ” button to program)
Total Closure Lock Output (press “ start ” button to program)
This changes the system’s doorlocking outputs to suite different vehicle requirements The total
closure setting provides a 28 second lock pulse (press LOCK or UNLOCK is during the pulse to
stop it) and a 08 second unlock pulse
Feature #9 Remote Start Lock Control
Off (press “ lock ” button to program) - DEFAuLT
Lock After Start (press “ unlock ” button to program)
unlock before start
(press “
trunk
” button to program)
unlock Before RS & Lock After RS (press “ start ” button to program)
This feature allows for OEM alarm/lock control in relation to remote start operations thus eliminat-
ing extra wiring for OEM alarm control
Feature #6 Blue Satellite Port, Blue Wire Function
ignition
(press “
lock
” button to program)
Status / GWR (press “ unlock ” button to program) - DEFAuLT
Defrost Pulse (press “ trunk ” button to program)
Pulse After Engine Off (press “ start ” button to program)
horn (press “ lock ” & “ unlock ” button to program)
This determines the function of the Blue wire on the Blue satellite relay port
The Status setting turns on briefly before the Ignition output and stays on during remote start
mode The other pulse settings give a 08 second pulse under the selected condition Defrost
Pulse will send a pulse after start only when the cabin temperature is below freezing (32 degrees
F / 0 degrees C)
20