ExtendAir® eMIMO™ Digital Microwave Radios
208398-002
8
2014-01-07
Mounting
As shown in the figure at the right, rc models
mount using a flat plate and band clamps to
secure the unit to the pole. No elevation or
azimuth adjustment is required as adjustment
is made using the antenna mechanics.
For r models with integrated antennas, to pole mount the unit, reference the
following illustration and follow the procedure. These parts are included in the
mounting kit:
Bracket assembly (
and
)
2 U-bolts (
)
4 Lock nuts (
)
4 Flat washers (
)
8 Hex head screws (
)
1.
Attach bracket
to the radio body as
shown, using four hex head screws.
2.
Attach bracket
to the pole with the two
U-bolts,using the lock nuts and washers.
3.
Position bracket
relative to the desired antenna height and elevation.
4.
Partially insert two hex head screws in the lower screw holes of the pole
bracket
.
5.
Insert two hex head screws in the upper holes of bracket
to temporarily
secure the radio before making final adjustments.
6.
Once the units at both ends of the link are mounted, align and properly
adjust them, and tighten all screws.
Extracting the I&M Guide
Click the
Manual
navigation link. The browser displays the PDF file. Click the
Save
button in the PDF toolbar to save the manual on the local system.
Note:
Keep the lock nuts slightly loose for lateral adjustment of the
bracket before final tightening.
Note:
Leave enough of the screw heads extending so that you can
slide bracket
over them, allowing you to pivot the radio and align
the slotted holes with the upper screw holes.
