Exalt Communications, Inc.
r-series
Installation and Management Manual
5000007 (ETSI)
23
2007-02-12 (draft)
LED Indicators
Table 4 provides details of the LED indicators on the r-Series radios. Note that there are two
LEDs, labeled top and bottom, associated with each connector. See Alarms Page on page 59 for
information on how the Exalt GUI displays LED status.
Table 4
LED indicators
Location Type
Function
T1/E1 2&4
Top
Green LED Solid when T1 clocking is present for input #2.
T1/E1 2&4
Bottom
Green LED Solid when T1 clocking is present for input #4.
T1/E1 1&3
Top
Green LED Solid when T1 clocking is present for input #1.
T1/E1 1&3
Bottom
Green LED Solid when T1 clocking is present for input #3.
GPS/RSL
Top
Green LED (Future implementation)
GPS/RSL
Bottom
Green LED (Future implementation)
Power/Ethernet
Top
Green LED Solid when proper power is applied.
Power/Ethernet
Bottom
Green LED (Future implementation)
Power Injector
DATA+POWER
Left
Green LED Solid when no alarm conditions are present.
Flashing when in alarm condition.
While RESET button is pressed:
Solid when in major alarm condition (traffic affecting).
Flashing when in minor alarm condition (not traffic affecting).
Off when no alarm conditions are present.
DATA+POWER
Right
Green LED Solid when proper power is applied.
During boot up, the DATA+POWER left LED on the power injector is solid green for
approximately 30 seconds, and then turns off briefly. The antenna alignment buzzer then
activates for approximately two seconds, and then the LED flashes once. After boot up