Rectifying faults
Check the machine type setting
50
099-004968-EW501
13.09.2021
Wire feed problems
Contact tip blocked
Clean and, if necessary, replace.
Setting the spool brake
> see 5.1.10.4 chapter
Check settings and correct if necessary
Setting pressure units
> see 5.1.10.3 chapter
Check settings and correct if necessary
Worn wire rolls
Check and replace if necessary
Wire feed motor without supply voltage (automatic cutout triggered by overloading)
Reset triggered fuse (rear of the power source) by pressing the key button
Kinked hose packages
Extend and lay out the torch hose package
Wire guide core or spiral is dirty or worn
Clean core or spiral; replace kinked or worn cores
7.2 Check the machine type setting
After switching on, the machine type that has been set is displayed for a short time, denoted as
"tyP".
If the machine type displayed does not match the machine, you have to correct this setting.
7.2.1 Setting the machine type
Operating ele-
ment
Action
Result
1 x
Switch off the welding machine
+
Keep both push-buttons pressed
1 x
Switch on the welding machine; the display shows “Anl”.
With “Anl” on the display, set the machine type:
0 ---------- Saturn 251 FKG
1 ---------- Saturn 301 FKG
2 ---------- Saturn 351 FKG
3 ---------- all decompact (DK, DG FDG, FDW)
7 ---------- Mira 301 FKG
After a few seconds, the selected machine type is applied and the dis-
play switches back to the welding parameter nominal values.
