15
Ewbank, 38 Bluestem Road, Ipswich, Suffolk, IP3 9RR Tel. 01473 271 272
Fig.8
Fig.9
Fig.10
6. Securing the hose (Fig.8)
• Once you have wound the high pressure hose
back around the hose reel, it can be locked in
place by pushing the connector part into the
gap between handle and hose reel
APPLIANCE START UP
IMPORTANT:
turn on the water supply before you
start the device and the “ON/OFF” switch is in the
“OFF” position (Fig.9)
1. Park the appliance on an even surface
2. Insert the mains plug into the socket
Water supply
For connection values, see type plate.
ATTENTION
Impurities in the water can damage the high-pressure
pump and the accessories.
3. Attach garden hose to water supply and turn on
at the tap
CAUTION
o
Do not connect to potable water system
o
The water supply must not exceed 0.7MPa
o
The pressure washer must only be used with clean water, use of unfiltered water
containing corrosive chemicals will damage the pressure washer
4. Bleed the device as follows prior to operation:
i) Release the safety lock button on the spray gun by pushing the safety lock button from right
to left
ii) While pointing the spray gun in a safe direction, squeeze the trigger on the spray gun until
there is a steady stream of water, letting the water and air out of the hose
iii) Turn on the appliance by turning the “OFF/ON” switch to the “ON” position (Fig.10)
iv) Squeeze the trigger on the spray gun to begin pressure washing
ATTENTION:
when not in use push the safety button back to lock the trigger.
PRODUC
T A
SSEMBL
Y / OPERA
TING INSTRUC
TIONS
