EVVO 20000TLG23P~EVVO 33000TLG23P
EVVO 20000TLG23P~EVVO 33000TLG23P
21
22
Many EVVO 20000TLG23P~EVVO 33000TLG23P installation
Figure3-4 Moving the inverter (2)
Step 2
Lift the inverter from the packing case and move it to the installation position.
200mm
100mm
3.5 Moving the inverter
This topic describes how to move the inverter to the installation position
horizontally
Procedure
Step 1
Open the packing, insert hands into the slots on both sides of the inverter and hold
the handles, as shown in Figure 3-3 and Figure 3-4. Two persons are required to move the
inverter.
Figure 3-3 Moving the inverter (1)
End
3.6 Installing the inverter
Step 1
To determine the position for drilling holes, level hole positions, and then mark the
hole position by using a marker, use the hammer drill to drill hole on the wall. Keeping
the Driller perpendicular to the wall, do not shake when drilling, so as not to damage the
walls. If the aperture errors, need to reposition.
Step 2
The expansion screw is vertically inserted into the hole, pay attention to expanding
screw insertion depth (not too shallow).
Step 3
Putting the rear panel on the wall, the rear panel is fixed by the nuts.
Step 1
Step 2
Step 3
3
0
0
mm
1
0
0
0
mm
To prevent device damage and personal injury, keep balance when moving the inverter
because the inverter is heavy.
Do not put the inverter with its wiring terminals contacting the floor because the power
ports and signal ports are not designed to support the weight of the inverter Place the
inverter horizontally.
When placing the inverter on the floor, put foam or paper under the inverter to protect its
shell.
Attention
