EVVO 20000TLG23P, User Manual

Page: 27 / 36

EVVO 20000TLG23P~EVVO 33000TLG23P EVVO 20000TLG23P~EVVO 33000TLG23P
47 48
(A)
“Enter Setting” Interface as below:
1
.
Enter Setting
1. Set time 12. Set Start Para
2. Clear Produce
13. Set Safety Volt
3. Clear Events
14. Set Safety Freq
4. Set Country Code
15. Set Insulation
5. On-Off Control
16. Relay Test
6. Relay Command
17. Set Reactive
7. Enable Set Country
18. Set Power De-rate
8. Set Total Energy
19.PE Line Control
9. Set Mod-bus Address
20.Set Re-flux
10. Set Input mode 21.Setting P(f)
11. Set Language
22.Setting Q(v)
23.Control 81. S1
Set Time
Users press
“Back” button to enter “1. Enter Setting” interface, Press “OK” button to
enter main setting interface. Enter
“1. Set Time” by pressing “Up” button or “Down”
button, then
press” OK“button and start to set up time.
Time set from year, month, day, minutes, and seconds in turns,
“Up” button or “Down
“button to choose different value to set each date. Set each value is needed to press
“OK” button to confirm setting. “success” is displayed if the setting time is correct,
“fail” means failure settings.
Clear Produce
Users press
“Back” button to enter “1. Enter Setting” interface, Press “OK” button to
enter main setting interface. Then Enter
“2. Clear Produce” by pressing “Up” button or
“Down” button, press “OK” button and start to clear produce. “success” is displayed after
settings.
Clear Events
Users press
“Back” button to enter “1. Enter Setting” interface, Press “OK” button to
enter main setting interface. Enter
“3. Clear Events” by pressing” Up” button or “Down”
button. Press
“OK” button and start to clear events. “success” is displayed after settings.
Set Country Code
Users press
“Back” button to enter “1. Enter setting” interface, Press OK button to enter
main setting interface. Enter
“4. Set Country Code” by pressing “Up” button Or “Down”
button, press
“OK” button and enter “Input Password” Setting interface (default: 0001). If
it's shown "set disable" on the screen, then you can NOT choose the operating country,
you should enable country setting through "7. Enable Set Country" interface. If it's shown
"set Country code?" on the screen, then press Confirm button to start country setting.
"Success" will be shown on the screen after a successful country setting.
User can check current country code in System Info>>5. Country.
Note: Country code changing will take effect after inverter reboot.
Table 6-1 country code setting