3722-IG-002 Installation and User Manual
February 6, 2019
22
Testing and Fault Modes
With the communications required between the EVSE and the Electric Vehicle, it is recommended that the installer use a
Control Module Inc. Model 3840-001 hand-held Electrician tester. This will thoroughly check out the EVSE, before using an
Electric Vehicle.
The primary function of the Data Router (Figure 20) is to display its operational status. The unit is equipped with five status
LEDs:
Blue (Power):
Indicates primary power is applied.
Yellow (Connect):
When EVSE is ready to charge the car (having either pushed the ON button on the wall or having
been authorized if controlled by a Payment Module), it starts blinking, indicating the cable is ready to
be connected. Once plugged into the car, it shuts off.
Green (Charging):
After plugging the J1772 connector into the car it starts blinking, indicating the car is charging. Once
the car is fully charged, it turns on solid.
Red (Problem):
Indicates a problem has occurred. (Refer to the Status Indicator Chart, on page 23).
Orange (Reserved): When lit, the EVSE has been reserved for use by another vehicle.
See the Status Indicator chart on the following page for complete status details.
Figure 20
