EVS XT2+, Technical Reference Hardware Manual

Page: 63 / 87

XT2+ Series DISK RECORDER - Version 10.05 - Hardware Technical Reference Manual Issue
10.05.A EVS Broadcast Equipment SA – July 2011
55
TF (transfer)
Blinks green while data transfers occur between the COD module and the
HCTX board
M1, M2, M3, M4 not yet used
G
ENERAL
C
ONNECTIVITY ON THE
V3X COD A
AND
COD B
M
ODULES
This section describes the connector assignments and layout for the video
standards SD 525i, SD 625i, HD 1080i and HD 720p.
The specific connectivity for HD 3D/1080p Dual Link and 3D/1080p single link
3Gbps is described in dedicated sections.
Changes in Connector Assignments from Multicam 10.04
On XT2+ servers equipped with DualPower V3X video codec boards, the
assignment of video connectors on the rear panel has been modified to reflect the
new configurations available from Multicam 10.04.
Consequently, the following changes are applied to the connectors:
•
The center left connector of a group of video connectors on the rear panel is
initially connected to the J5 connector on the V3X module.
It should be connected to J1 if monitoring (CVBS or SDI) is required in SD or
HD mode.
Apply caution if you need to move the corresponding cable between J1 and J5
connectors on the V3X module: do not apply excessive traction or pressure,
and make sure pressure or traction is applied in the correct alignment of the
connectors, never sideways.
• The J3 connector, previously labelled ‘SD OUT’ and located on the center left
position, is now labelled ‘OUT B’ and located at the bottom right position.
From Multicam 10.04, it is the output for the left eye or link 2 when working
respectively with 3D or 1080p Dual Link formats.