XT2+ Series DISK RECORDER - Version 10.05 - Hardware Technical Reference Manual
Issue
10.05.A
EVS Broadcast Equipment SA – July 2011
47
B
LOCK
D
IAGRAM
J
UMPERS ON THE
COHX
B
ASE
M
ODULE
ST1, ST2:
These 2 jumpers must be installed on the last COHX board of the
server (i.e. on COHX #1, 2 or 3 if there are respectively 1, 2 or 3
COHX board installed in the server)
ST3 (SPARE): « parking » for jumpers for ST1 and ST2 when these are not used
ST4 (only on
COHX with
genlock) :
It must be set to HiZ (or not installed).
Note that the Genlock Loop connector on the back panel of the
XT2+ server must always be terminated with a 75 Ohm load if it
is not used.
ST5 :
It defines the position of the board inside the server.
It must be set to « 1 » for a COHX with genlock, and to « 2 » or
« 3 » for a COHX board without genlock, depending on its
position in the server.
Summary of Contents for XT2+
Page 1: ...Technical Reference Hardware Version 10 05 July 2011 Production Playout Server ...
Page 2: ......
Page 4: ......
