Issue
10.05.A
XT2+ Series DISK RECORDER – Version 10.05 - Hardware Technical Reference
EVS Broadcast Equipment SA – July 2011
38
could cause additional line delays and prevent the proper operation of XNet.
3.
If the start-up of the network at a specific speed does not work properly and
all machines are apparently configured properly and the Multicam is actually
started on all of them, this can be due to the fact that the selected cables to
connect all EVS servers together are not suitable or too long to operate at
such a speed. You can decrease the speed of the SDTI network on all
machines and try working in this mode. The number of simultaneous real-time
transfers you can achieve is of course reduced.
4.
While working at 1485 Mbps, if the connection cannot be established, please
make sure that all equipments are set to the same speed and connected to the
non-relay connectors. All equipments should be started if not connected to an
XHub.
5.
It is recommended to use XHub if the network speed is set to 1485 Mbps.
6.
Once the network has been established, if the system acting as the network
server is disconnected or shut down, another system will automatically be
assigned to act as a new network server. The switch is automatic. The next
machine to be automatically assigned as new network server is the one with
the highest serial number in the SDTI network.
Summary of Contents for XT2+
Page 1: ...Technical Reference Hardware Version 10 05 July 2011 Production Playout Server ...
Page 2: ......
Page 4: ......
