EVS Broadcast Equipment SA
19
Audio_CtrlA
With this item you select how audio proc amp presets for Channel A
are controlled: Manually (
Manual
) or via GPI-triggers (
GPI
,
GPI-
A
,
GPI-B
or
GPI-C
). Default is
Manual
Audio_Prst_ActA
With this item you can manually change the currently active preset of
channel. Can be any preset between 1 and 16. By default it is set to 1.
All menu settings that are preceded with a ‘
#Ins
’-prefix are part of
the preset.
Audio_Prst_EditA
Here you can select which of the 16 selectable presets you want to
edit for Channel A. Changing this will not change the active preset,
unless the currently active preset is the same you are going to edit. All
menu settings that are preceded with a ‘
#Ins
’-prefix are part of the
preset.
#Silence-TimeA
If the embedded audio contains silence, this can be reported by the
card. This setting allows you to determine how many seconds it takes
before the card reports the silence. This setting can be set in a range
from 1 sec to 255 sec. The default setting is 10sec.
#Silence-LevelA
With this setting you set a loudness threshold for the silence detection.
Can be set between -100 and -20 dBFS. When the audio goes below
this value, a silence alert is triggered. Default is
-60dBFS.
#Enc_in_Ch01/04
~
#Enc_in_Ch05/08
These settings allow you to select the source of the audio channels
which need to be encoded by the on board Dolby CAT1100.
You can choose between the following values:
▪
Source for Ch01/08: SDI-de-embed Ch1 (value ‘00’), Ch2 (value
‘01’) to Ch16 (value ‘0F’), Dec1 (value ‘10’) to Dec8 (value
‘17’), Dec_mon1 (value ‘1B’), Dec_mon2 (value ‘1C’)
00010203
Ch1
Source
Channel
Ch2 Ch3 Ch4
Defaults are (source: SDI_Input_1, channels: straight):
▪
#Enc_in_Ch01/04 = 00010203
▪
#Enc_in_Ch05/08 = 04050607
Summary of Contents for Synapse U4T100
Page 1: ...4K 3840X2160 ULTRA HD 4 WIRE TOOLBOX WITH OPTIONAL DOLBY E PROCESSING ...
Page 67: ......
Page 68: ......