EVOnet network camera, User Manual

Page: 14 / 74

User’s Manual
8
Cut off the power from the camera. → Poke a straightened paperclip into the factory reset switch
hole. → Turn on the power while holding the reset switch → Release the switch in about 5 seconds
after the Power LED blinks. → The camera resets to factory defaults and restarts after completing
the factory reset.
You can perform a factory reset while the camera is turned on by pressing the factory reset switch
and releasing the reset switch. A factory reset also can be performed remotely by running the INIT
program. The camera restarts after completing the factory reset. Refer to the INIT User’s Manual
for details on remote factory resetting.
Lens
HD Model
①
Focus Lever : Adjust the focus by turning the lever clockwise or counterclockwise.
Once it is set, twist the setscrew clockwise to lock it.
②
Zoom Lever : Adjust the zoom by turning the lever clockwise or
counterclockwise. Once it is set, twist the setscrew clockwise to lock it. The
lever length may be different depending on model type.
Full HD Model
①
Focus Lever : Adjust the focus by turning the lens clockwise or
counterclockwise. Once it is set, twist the lever clockwise to lock it.
②
Zoom Lever : Adjust the zoom by turning the lever clockwise or
counterclockwise. Once it is set, twist the setscrew clockwise to lock it.
The lever length may be different depending on model type.
Input/Output Device Ports
①
Alarm In/Out
②
Audio In/Out
③
Video Out
④
Power
⑤
Network LED
⑥
Network Port
⑦
Power LED
 Alarm
− OUT : Connect an alarm-out device to the OUT and GND (Ground) connectors. Active Low
(Open Collector output) is a relay output which sinks 30mA @ 5 VDC.