Evolution RAGE3-DB, Original Instructions Manual

Page: 25 / 116

25
www.evolutionpowertools.com
EN
ES
FR
• Tilt the Cutting Head to the 45
0
setting and recheck for
alignment with the Set Square.
• Repeat the above steps until the correct angular alignment
is achieved.
• Tighten the Adjustment Screw locknut securely once
alignment is achieved.
FENCE ALIGNMENT
The fence must be aligned at 90
0
(square) to a correctly
installed blade The rotary table must be set at ‘0
0
’ miter angle.
The Fence is fastened to the table with two socket head Hex
screws positioned at either side of the fence in elongated slots.
(Fig. 19)
• Ensure that the Cutting Head is in the locked down position
with the latching pin fully engaged in its socket
• Place a Engineers Square on the table with one short edge
against the Fence and the other short edge against the Blade
(avoiding the TCT tips).
(Fig. 20)
• If adjustment is necessary, loosen the four Fence adjustment
screws using a Hex Key
• Re-position the Fence in its elongated slots until alignment
is achieved.
• Securely tighten the socket head Hex screws.
MITRE ANGLE POINTER ADJUSTMENT
NOTE:
There are dual miter angle scales cast into the front of
the machines base. A small pointer attached to the rotary table
indicates the angle selected.
If necessary the pointer can be repositioned by loosening
its fastening screw using a #2 Phillips screwdriver. Adjust as
necessary, and then securely tighten the fixing screw.
(Fig. 21)
PREPARING TO MAKE A CUT
Slide Movement Adjustment
Before making a cut, check the sliding rails move smoothly with
no vertical movement when sliding back and forth. If the slide
moves too freely or there is vertical movement, adjust the grub
screws
(Fig. 50)
using a 4mm Allen key and 14mm spanner to
give more control or eliminate vertical movement in the slide.
Fig. 19
Fig. 20
Fig. 21
Fig. 50