Evolution RAGE3-DB, Original Instructions Manual

Page: 29 / 116

29
www.evolutionpowertools.com
EN
ES
FR
BEVEL CUTTING - TILTING THE CUTTING HEAD
A bevel cut
(Fig. 32)
is made with the rotary table set at 0
0
mitre.
NOTE:
It may be necessary to adjust the upper section of the
Fence to provide clearance for the moving Cutting Head.
The Cutting Head can be tilted from the normal 0
0
(perpendicular
position) to a maximum angle of 45 0 from the perpendicular to
the left hand and right hand sides. Bevel cutting is possible with
or without the sliding carriage system being deployed.
To tilt the Cutting Head to the left:
• Loosen the bevel lock lever. (Fig. 33)
• Tilt the Cutting Head to the required angle.
A protractor scale is provided as an aid to setting. (Fig. 34)
• Tighten the bevel lock lever when the desired angle has
been selected.
NOTE:
The bevel lock lever is spring loaded and this enables it
to be repositioned on its operating screw. Repositioning may be
necessary to avoid interference with other parts of the machine
when certain mitre angles are selected.
To reposition:
• Lift up the lever and turn to a convenient position.
• Release the lever.
Stand to the left side of the handle when making a cut.
When cutting is completed:
• Release the ON/OFF trigger switch, but keep your hands in
position and allow the blade to completely stop.
• Allow the Cutting Head has to rise to its upper position,
with the lower blade guard completely deployed before
removing yours hand(s).
• Return the Cutting Head to the perpendicular position.
• Tighten the bevel lock lever.
To tilt the Cutting Head to the right:
• Pull out the Right Hand Bevel Access Pin.
(Fig. 35)
Twist the
pin ¼ of a turn to keep it in the disengaged (outer) position.
• Loosen the bevel lock lever.
• Tilt the Cutting Head to the required Right Hand angle.
• Tighten the bevel lock lever.
Fig. 32
Fig. 33
Fig. 34
Fig. 35