PRIMACY
LAMINATION
8
INSTALLATION
Connecting the Printer
Connection to the power supply
!
The printer must be connected to a properly protected and earthed electrical installation.
FI: Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan.
NO: Apparatet må tilkoples jordet stikkontakt.
SE: Apparaten skall anslutas till jordat uttag.
DK: Printeren skal tilsluttes til en korrekt beskyttet og jordforbundet el-installtion.
• The print and lamination modules should be connected to their power supplies before proceeding.
• The ends of the 2 power cables should then be plugged into 2 earthed power sockets.
• The system is powered on: the Primacy Lamination control panel lights up showing that the system is working
properly. If the control panel does not light up, then either the installation has not been carried out correctly
or the printer is not working properly. Check the installation.
!
Before attempting any maintenance, always ensure that the power cables are unplugged. For your personal safety, ensure that the cable
and power supply unit remain easy to access, especially in the event of an emergency.
NOTE
To save energy, the printer and the lamination module will automatically switch to standby mode after 10 minutes of inactivity. They will switch
to hibernation mode after 30 minutes in standby mode.
The standby times can be configured in the Evolis Print Center. In standby mode, sending a print request restarts the printer, and briefly pressing
the control button (for 1 second) takes the printer out of hibernation mode.
Connecting the USB cable
!
Under no circumstances should you connect the USB data cable before the installation of the driver is complete.
Please refer to the section on driver installation in this chapter for further details, and follow the instructions carefully.
