Evinrude & Johnson E75DPLSCB, Service Manual

Page: 101 / 349

99
ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS
5
Ignition Timing
Use the Ignition Timing screen to check and
adjust EMM timing. EMM timing must be synchro-
nized to crankshaft position.
Refer to
TIMING ADJUSTMENTS
on p. 142.
Check timing after any of the following proce-
dures:
•
Powerhead replacement
•
Crankshaft replacement
•
Flywheel removal or replacement
•
CPS replacement
•
EMM replacement
•
EMM software replacement
IMPORTANT:
Make sure the timing pointer is
set and the outboard reaches operating tempera-
ture before making adjustments.
TPS Calibration
TPS Calibration synchronizes throttle plate open-
ing with throttle position sensor voltage.
Refer to
TPS Calibration
on p. 143.
Perform TPS Calibration after replacing or adjust-
ing any throttle body or throttle linkage parts.
Idle Speed Control
Use the Idle Adjust function to increase or
decrease IN GEAR IDLE speed. This adjustment
offsets the basic
EMM programming and will not
set an absolute fixed speed. After the offset is
changed, the
EMM continues to control engine
operation normally. Engine idle speed is not fixed.
006547
1. TPS Calibration button 006548
1. Idle adjustment 006540
1
1