Evil Pimp Kit, Operator'S Manual

Page: 15 / 17

No velocity
Low velocity
High velocity
Shoot down
Velocity is very erratic
Marker chops paint
Paintballs break in barrel
Paintball doesn’t load
Paintballs roll forward in barrel
Ball detents wear quickly
Marker fires with no paintball
in the chamber
Eye doesn’t work
Eyes are clean and turned on
and marker fires with no
paintball
Marker shoots once and will not
fire again with eye on.
Fires with eye off.
Ball rolls back off the eye
Ball rolls forward off eye
Internal Leak
LPR Leaks
LPR won’t adjust
LPR Creeps
Marker cycles but doesn’t fire
Marker shoots slow (BPS)
Marker gets first shot drop off
Marker does not fire with each
trigger pull
Hopper doesn’t fit
Lose often
Troubleshooting Troubleshooting
• Turn marker off then on to reset the eye.
• Remove eye cover and clean eye.
• Replace battery.
• Check for pinched eye wire. Replace.
• Clean eyes.
• Bolt positioning screw must be moved forward.
• Hold trigger for 3/4 of a second and the
marker will override the eye and fire once to
clear the ball.
• Replace ball detents if problem persists.
• Check LPR and make sure it is less than 170 psi.
• Check internal hoses for a loose or
damaged hose.
• Check for damaged cup seal.
• Turn it down. It should vent at 170 psi.
• Grease LPR.
• Degas marker, then make adjustments.
• Replace LPR seat seal.
• Grease LPR.
• Replace LPR seat seal.
• Inline regulator is too low or too high and marker
is overpressurized.
• Grease Ram.
• Hose to the back of the Ram is pinched.
• LPR is too low.
• Dwell is too low.
• Check hopper battery.
• Check Pimp Kit
™ battery.
• Buy faster hopper.
• Replace battery.
• Battery is low.
• Marker is not assembled correctly.
• Trigger is adjusted incorrectly.
• Hopper can’t keep up. Buy faster hopper.
• Use O-rings provided in parts kit or remove
O-rings from vertical feed.
• Practice more.
• Bolt installed improperly. See page 16.
• See page 8 for set up instructions.
• Check battery.
• Verify LPR is between 100-150 psi.
• Increase regulator output pressure.
(See page 11).
• Reg pressure that is way too high (400 psi or
more) can also lead to low velocity.
• Grease Ram
• Increase Dwell.
• Decrease Detonator regulator output pressure.
• Verify LPR is between 100-150 psi.
• Decrease Dwell.
• Tank not screwed in all the way.
• LPR needs to be lubed. (See page 20)
• Adjust LPR up; do not adjust above 150 psi.
• Your barrel is a bad match for your paint.
• Detonator
™ Regulator is not providing
a consistent output pressure and may need
oil run through it.
• Replace ball detents.
• Turn up BIP delay.
• Check bolt position and move bolt positioning
screw only if needed.
• Barrel diameter is too large or too small for the
paint you are using.
• Paint has gone bad and must be replaced.
• Check barrel centering O-ring and make sure it is
firmly seated.
• Bolt installed in front of Ram. Reinstall bolt properly.
• Replace ball detents.
• Your paint is really bad.
• When installing or removing bolt, do not push
the bolt forward or you will break off ball detents.
• Eyes are turned off.
• Eyes are dirty. Clean.
25 24