Evil Pimp Kit, Operator'S Manual

Page: 4 / 17

DO NOT EXCEED RECOMMENDED INPUT OR OPERATING PRESSURE.
The EVIL ® Pimp Kit ™ paintball marker may be powered by regulated compressed air,
or regulated nitrogen only.
Operating Pressure and Input Pressure
• Operating pressure range: 150-400 psi.
• Respirator Low Pressure Regulator (LPR) Range: 100-150 psi.
• Recommended maximum input pressure is 175 p.s.i. into the marker
from the LPR.
• Exceeding 175 psi into marker can damage solenoid and void warranty.
• Maximum inlet to Detonator regulator 1000 psi.
• Do not exceed recommended pressures.
Valve -Cylinder Connection
The valve on a cylinder is to remain screwed into the cylinder; Figure 1. Should it loosen,
the cylinder may detach from the valve with extremely dangerous force. Call manufacturer
or take to qualified personnel for inspection
if valve and cylinder begin to separate or leak.
Every time a cylinder is filled, the connection
between the valve and cylinder must be inspected.
If any looseness or leak is detected between the
valve and the cylinder, do not fill. Drain cylinder
and call manufacturer or take to qualified
personnel for inspection.
DO NOT OVERFILL ANY CYLINDER. AN OVERFILL CAN CAUSE THE SAFETY
BURST DISK OR THE CYLINDER ITSELF TO RUPTURE.
Hydrostatic Testing Date
Many cylinders are required by the U.S. Department of Transportation to be hydro
tested at periodic intervals, with the interval varying according to cylinder type. The
date of the cylinder’s initial or later testing appears on the cylinder. A cylinder that
is out of date for hydrostatic testing must not be filled or used.
The safety rules for handling compressed gas or air must be followed at all times.
A COMPRESSED GAS OR AIR CYLINDER IS A PRESSURE VESSEL. FOLLOW
RULES FOR SAFE HANDLING OF COMPRESSED GAS OR AIR. ALL FILLING OF
COMPRESSED GAS OR AIR CYLINDERS, AND ALL REPAIRS TO A MARKER’S
POWER SYSTEM OR ITS COMPONENTS MUST BE PERFORMED BY QUALIFIED
PERSONNEL.
Filling Compressed Gas/Air
An overfill of any compressed gas or air cylinder can cause the safety burst disk
(Figure 1) on the cylinder to burst, or the cylinder itself to rupture. A cylinder may
rupture with extremely dangerous, and potentially lethal force. Use properly rated
discs only.
Fills must be performed by qualified personnel. A cylinder must not be filled beyond
the cylinder’s capacity per the U.S. Department of Transportation. A cylinder’s rated
capacity appears on the cylinder itself.
Compressed Gas/Air Compressed Gas/Air
Figure 1. Valve-cylinder
connection.
Burst Disk
USE N
2
ONLY! DO NOT USE CO
2
ON YOUR PIMP KIT ™ !
7 6