• Grease Ram once every 10,000 shots. Do not use OIL.
We recommend EVIL
®
Pus.
• Apply a small amount to the shaft. Figure 1.
• Remove the cap and lightly grease the O-ring inside the cap. Figure 2.
• Grease the back of the shaft. Figure 3.
• Apply grease to the four external O-rings. Figure 3.
• Keep grease away from holes to keep your solenoid working properly. Figure 3.
Greasing the Ram
With the bolt removed, remove the Ram from the back of the Pimp Kit.
™
The easiest way to not damage the Ram O-rings is to unscrew the Ram 5 1/2 full turns
and pull it firmly straight out the back without rotating it.
Respirator LPR Adjustment
• Always degas the marker before disassembling the LPR.
• Unscrew the entire LPR Cap from the front of the marker. (Figure 1)
• Unscrew the Poppet Shaft from the Nose Piece and remove the Poppet Shaft
from the Cap. (Figure 2)
• Grease the threads of the Poppet Shaft where it screws into the Nose Piece.
• Clean and grease the O-ring on the Poppet Shaft.
• Clean and grease the tip of the Poppet Shaft.
• Keep grease away from non-threaded end of the Poppet Shaft. (Figure 3)
Figure 1
Figure 2
Figure 3
grease here
grease here
keep grease away
from here
Respirator LPR maintenance
• Always degas the marker before
adjusting the LPR.
• From the front of the marker, screw the
cap further in (clockwise) to raise the
LPR pressure. Unscrew the cap to lower
the LPR pressure.
• Optimum performance can usually be
achieved with an LPR pressure of 100
to 150 psi. Do not adjust over 170 psi.
grease here
grease here
grease O-rings here
keep grease away from holes
LPR Seat Seal
If the LPR creeps or doesn’t adjust properly after greasing
the internals, the seat seal may need to be replaced.
• Unscrew the LPR base from the Pimp Kit.
™
• Carefully unscrew the brass seat base from the LPR base
and remove the seat seal.
• Fit new seal carefully and completely into the seat base
and reassemble.
grease here
Figure 1
Figure 3
Figure 2
Decrease (-)
Increase (+)
LPR
Gauge
Punch Ram Maintenance
LPR Adjustment and Maintenance
21
20
LPR Maintenance Cont.
Summary of Contents for Pimp Kit
Page 1: ...Version 1 0...
