cuiheat.com
126345-01D
4
Figure 1 - Product Identification
Six Piece Log Set
(7 pc. for 30" models)
Piezo
Igniter
Flame Adjustment
Knob
Control
Knob
Base Assembly
SAFETY
Continued
16. If optional remote control is used, make sure the selector switch
is in the OFF position when you are away from home for long
periods of time.
17. Operating heater above elevations of 4,500 feet may cause pilot
outage.
18. To prevent performance problems, do not use propane/LP fuel
tank of less than 100 lb. capacity (propane/LP units only).
19. Provide adequate clearances around air openings.
PRODUCT IDENTIFICATION
OPTIONAL REMOTE CONTROL ACCESSORIES
There are four optional controls that can be purchased separately for:
• wall switch
• wall thermostat
• hand-held ON/OFF remote
• hand-held thermostat remote
See Accessories, Page 31.
The wall thermostat or thermostat remote may not be used where
vented decorative listing is required.
LOCAL CODES
Install and use appliance with care. Follow all local codes. In the
absence of local codes, use the latest edition of The National Fuel
Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
25 West 43rd Street, 4th floor
New York, NY 10036
National Fire Protection Association, Inc.
1 Batterymarch Park
Quincy, MA 02169-7471
COMMONWEALTH OF MASSACHUSETTS REQUIREMENTS
These appliances are approved for installation in the US state of
Massachusetts if the following additional requirements are met:
• Un-vented Room Heaters shall be installed in accordance with
527 CMR 30.
• Installation and repair must be done by a plumber or gas fitter
licensed in the Commonwealth of Massachusetts.
• The flexible gas line connector used shall not exceed 36 inches
(92 centimeters) in length.
• The individual manual shut-off must be a T-handle type valve.
• Un-vented appliances may NOT be installed in bedrooms or
bathrooms.
• A working smoke detector must be installed in the area where
vent-free appliances are installed.
Seller of un-vented propane or natural gas-fired supplemental room
heaters shall provide to each purchaser a copy of 527 CMR 30 upon
sale of the unit.
UNPACKING
CAUTION: Do not remove data plates from grate
assembly. Data plates contain important warranty and
safety information.
1. Remove logs and heater base assembly from cartons.
NOTE: Do not pick up heater base assembly by burners. This could
damage heater. Always handle base assembly by grate.
2. Remove all protective packaging applied to logs and heater for
shipment.
3. Check appliance for any shipping damage. If appliance is damaged,
promptly inform dealer where you purchased the appliance.
PRODUCT FEATURES
OPERATION
This heater is clean burning. It requires no outside venting. There is
no heat loss out a vent or up a chimney. Heat is generated by realis-
tic flames. This heater is designed for vent-free operation with flue
damper closed. It has been tested and approved to ANSI Z21.11.2
standard for unvented heaters. State and local codes in some areas
prohibit the use of vent-free heaters. This heater may also be oper-
ated as a vented decorative (ANSI Z21.60) product by opening the
flue damper.
SAFETY DEVICE
This heater has a pilot with an Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off the heater if there is not
enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo Igniter. This system requires no matches,
batteries or other sources to light heater.
