evertz 7890IXG, User Manual

Page: 31 / 70

7890IXG
Internet Exchange Gateway
Revision 2.3
Page - 23
Figure 4-20 : WebEASY
®
- Internet Input IP Stream
If any of the settings are mismatched the signal will not go through. Please ensure all settings are
configured correctly.
4.4.4. Data Loss on RX Side:
The numbers of unrecovered (Data Lost) and recovered (Data Saved) Input data packets received by the
RX side can be detected by going to the “Internet Input IP stream” tab on the RX side webpage at the
bottom under “ARQ Status.” “Unrecovered” means the data packets were dropped and lost by the RX
side. Recovered signifies the number of data packets that the RX side has successfully recovered. For
best operation, the number of unrecovered packets should always be 0. If this is not the case, verify the
configuration settings between the TX and RX sides and check the Bitrate at both ends (Transmit status
(TX), Network Status (RX)). If the bitrate and all configurations match and there is still data
loss(unrecovered), the user may increase the Target Latency number. This will delay the time process of
the RX side card (Please note: This setting will reduce the number of unrecovered data packets but will
also add latency between TX and RX side).