7700 MultiFrame Manual
7736CEM Composite Encoder with Monitoring
Revision 1.5
Page - 57
*Grey background indicates un-implemented or un-tested features
7.12.3. Initiating a Software Upgrade
Utilities
This menu item is used to initiate an upgrade of the module software.
In addition to the software upgrade support detailed in this manual
(See the
Upgrading Firmware
section of this manual for more
information), you can initiate an upgrade with this command. This will
allow you to upgrade the software without unplugging the card and
changing the upgrade jumper.
After selecting the upgrade operation, you must change the command
to
Yes
and press the pushbutton before the upgrade can take place.
You can abort the operation by pressing the pushbutton when
Cancel
is displayed.
After the upgrade has finished, the unit will automatically restart and
run in normal operating mode.
Upgrade
Yes
Cancel
7.12.4. Restoring the CEM to its Factory Default Configuration
Utilities
This menu item is used to restore all controls back to their factory
defaults.
After selecting the reset operation, you must change the command to
Yes
and press the pushbutton before the command takes place. After
the command, all parameters will be set to their factory default. You
can abort the operation by pressing the pushbutton when
Cancel
is
displayed.
Factory reset
Yes
Cancel
7.13. CLEAR FAULTS AND PEAKS
Clear faults and
peaks
This menu item on the top level menu provides a convenient method to clear
any fault conditions and reset audio peak holds. You can also perform the
clear by pressing the toggle switch up or down when not in the menu structure.
Clear,
Cancel