EverRide Hornet EZYN2048S, Operator'S & Parts Manual

Page: 63 / 110

55 - MOWER ASSEMBLY INSTRUCTIONS
SETUP INSTRUCTIONS
Mowers are shipped partially assembled. After
uncrating the power unit and mower deck, initial
setup is required.
1. Remove all packaging. If the seat was not
installed at the factory, carefully set it aside
for later installation.
2. The motion control arms have been lowered
during packaging. Remove the loose 3/8-16
x 1.50 bolts from the handles and reinstall
them in the location shown.
If your unit does not have the seat installed, pro-
ceed with step 3.
3.
Remove the 5/16 flat washers and locknuts
from the four studs protruding from bottom of
the seat.
4. Route the seat switch end of the wiring har-
ness up through the seat plate. Plug the har-
ness into the seat switch located on the bot-
tom of the seat.
5. Connect the seat to the seat plate by sliding
the 5/16 studs through the seat plate and se-
cure it in place using the 5/16 flat washer’s
and locknuts removed in step 3. The front left
stud requires the installation of a P-Clip which
was slid over the harness durring assembly.
Route the harness as shown.
RADIATOR ASSEMBLY & INSTALLATION
If your radiator was not installed at the factory,
Remove Loose
Bolt And
Install
Here
RH Upper
Hose
LH Lower
Hose
Plug Harness Into the
Bottom Of The Seat
Bottom View Of Seat Plate