EverRide Hornet EZYN2048S, Operator'S & Parts Manual

Page: 14 / 110

SAFETY - 6
Be sure the engine and rotating blades have
stopped before putting hands or feet near the
blade.
Disengage the blade drive when transporting the
machine across drives, sidewalks, etc. Never raise
the mower deck while the blades are turning.
Do not put hands or feet under or into the mower
when it is running.
Do not touch the engine or muffler when the en-
gine is running or immediately after the engine
has stopped. These areas may be hot enough to
cause serious burns.
Do not drive the machine on streets or highways.
Watch for traffic when crossing streets or while
mowing close to roads.
Always inspect the mower for damage after striking
a foreign object. Always repair or replace dam-
aged parts before restarting the mower deck.
Do not operate the power unit without the mower
deck attached.
Make sure the machine and all attachments come
to a complete stop before dismounting.
Before dismounting, disengage the PTO, lower
all attachments, place the control levers in the
park position, turn off the engine, and remove the
key.
OPERATING ON SLOPES
Avoid starting or stopping when going up or down
a slope. Keep all movements on a slope gradual
and slow. Do not make sudden changes in speed
or direction.
If tires lose traction while on a slope, disengage
the mower blades and back slowly and gradually
down the slope.
Do not turn on slopes unless necessary, and then
turn slowly and gradually downhill if possible.
Use extra caution when mowing on slopes. If you
are unable to back up on the slope, or if you do not
feel comfortable on it, then do not mow it.
Mow across slopes, not up and down, to avoid
machine tip-over. Do not mow slopes or hills that
are too steep for safe operation.
Do not try to stabilize the machine by putting your
foot on the ground.
ROLL OVER PROTECTIVE STRUCTURE
(ROPS)
Do not weld, drill or alter the ROPS. Damaged
ROPS must not be straightened or used. If dam-
age does occur, consult your
EverRide
Dealer and
replace all damaged parts.
If the ROPS is lowered or removed from the power
unit for any reason, it must be erected and/or
refitted immediately. Original bolts or equivalent
replacements must be used and tightened to the
correct torque.
Do not attach chain, ropes, or cables to the ROPS
for pulling purposes as this will cause the mower
to tip backwards.
EverRide does not recommend the use of the
mower with the ROPS removed.