EverRide Hornet EZYN2048S, Operator'S & Parts Manual

Page: 34 / 110

OPERATING THE MOWER - 26
WARNING: Never operate the mower
with the discharge shield in the raised
position.
UNEVEN TERRAIN
Pre-plan mowing over uneven terrain so the grass
will be dry, minimizing wheel slippage and spin-
ning, which will damage the turf.
WARNING: To avoid the loss of control
and to prevent overturning the mower,
always mow across slopes, never up
and down.
Pass diagonally through sharp dips. Avoid sharp
drop offs completely to prevent “hanging up” the
mower.
CAUTION: Keep the power unit mo-
tion control arms forward when going
downhill.
Before mowing, check the area to determine the
best procedure. Consider the grass type and
height, and the type of uneven terrain on which
the mowing is to take place.
Avoid sudden starts and stops while traveling up
or down hill, and slow the ground speed while
turning.
GRASS DISCHARGE
The mower deck has been designed to provide
maximum air flow for an even discharge of grass
clippings. When mowing tall, or lush grasses,
select a lower mower ground speed, or reduce
the width of cut, for the best discharge
efficiency.
For the best lawn appearance, do not mow when
the grass is wet or heavy with dew. Wet grass
could plug the discharge area of the mower, cre-
ating an unnatural load through the blades and
spindles, possibly damaging the mower deck
belt. Wet grass will also leave unsightly clumps
on the lawn.
If the mower deck should become clogged, back
the unit out of the uncut grass. If the mower will
not clear itself, turn the PTO off, raise the deck,
shut off the engine, set the brake, remove the key,
disconnect the negative battery cable and clean
the bottom of the deck.
WARNING: The operator should never
attempt to leave the mower seat, with
the mower blades rotating, with the
mower in motion, or when the engine
is running.
In medium and heavy cutting conditions, mow so
the discharged clippings will be AWAY from the
uncut grass. In light cutting, discharged clippings
can be directed onto the uncut grass, allowing
them to be recut
finer, leaving the lawn almost free
of unsightly clippings.
1/4“ - 1/2” (6mm - 13mm)