EverRide Hornet EZYN2048S, Operator'S & Parts Manual

Page: 49 / 110

41 -
LUBRICATION AND MAINTENANCE
1. Park the machine safely.
2. Cut the
flow to the fuel filter by setting the fuel
shutoff valve to off.
3. Disconnect the hose clamps from the fuel
filter.
4. Slide the fuel line off of both ends of the fuel
filter.
5. Install the new fuel
filter paying close attention
to the flow direction noted on the fuel filter.
6. Turn the fuel shut off to the ON position.
The fuel pump can not be disassembled. If the fuel
pump fails, replace it with a new one.
FUEL/WATER SEPARATOR SERVICE
This unit is supplied with a fuel/water separator
that will pull out water and potential contaminants
to protect your fuel pump and engine. When
water is visible in the see-through bowl or engine
performance is noticeably reduced, service is
required.
1. Park the machine safely. Ensure all engine
components are cool before performing
maintenance on the vehicle.
2. Turn the fuel selector valve to the “off”
position.
3. Spin the see through sediment bowl off of
the mounting head by turning in a counter-
clockwise motion.
4.
Remove the used filter element and replace it
with a new element.
5. Thread the see through sediment bowl on to the
mounting head and tighten hand tight only.
6. Start the engine and check for leaks. Correct
as necessary with the engine off.
FLUSH & FILL ENGINE COOLANT
DANGER: NEVER remove the radiator
cap if the engine is hot. Steam and hot
engine coolant will spurt out and seriously
burn you. Allow the engine to cool down
before you attempt to remove the radiator
cap.
DANGER: Securely fasten the radiator
cap after you check the radiator. Steam
can spurt out during engine operation if the
cap is loose.
DANGER: Always check the levels of
the engine coolant by observing the
reserve tank.
Engine coolant contaminated with rust or scale
reduces the cooling effect. Even when extended
life engine coolant is properly mixed, the engine
coolant gets contaminated as its ingredients de-
teriorate. Replace the engine coolant every 400
hours or once a year.
1. Remove the radiator cap.
2. Loosen and remove the radiator hose and drain
the engine coolant.
3. After draining the engine coolant, reinstall and
tighten the radiator hose.
Mounting
Head
Filter
Element
Sediment
Bowl