16
CARE AND MAINTENANCE
For queries or additional product information, please call our Service Centre on:
087 997 0865
Please have your model name on hand.
www.everlastsa.co.za
Everlast/SA everlast_sa
GENERAL CARE
•
Always check equipment for wear and tear before use.
DO NOT
attempt to repair the equipment yourself, should
you have any difficulty with assembly, operation or use of the equipment contact the service centre 087 997 0865.
•
Inspect and tighten all parts before using the equipment and replace any defective parts immediately.
DO NOT
use the equipment again until it is in perfect working condition.
•
Periodically lubricate any moving parts with light oil to prevent premature wear and tear.
•
Use equipment for domestic use only. It is
NOT
intended for commercial, rental or institutional use.
GENERAL CLEANING
•
Use a soft, damp cloth to wipe the equipment.
•
The upright bike can be cleaned with a soft clean damp cloth. Do
NOT
use abrasives or solvents on plastic parts.
Please wipe your perspiration off the equipment after each use. Be careful not get excessive moisture on the computer
display panel as this might cause an electrical hazard or electronics to fail.
•
Keep equipment, especially the computer console out of direct sunlight to prevent screen damage.
•
Please inspect all assembly bolts and pedals on the machine for proper tightness every week.
STORAGE
Store equipment in a clean and dry environment
away from children.
TROUBLESHOOTING
PROBLEM
SOLUTION
No display on the computer console.
1.
Remove the computer console and check the wire
that comes from the computer console is properly
connected to the wire that comes from the
handlebar post.
2.
Check if the batteries are correctly positioned
and battery springs are in proper contact with
batteries.
3.
The batteries in the computer console may
be
dead. Change to new batteries.
Bike wobbles when in use.
Turn the rear stabiliser end cap on the rear stabiliser as
needed to level the bike.
Bike makes squeaking noise when in use.
Bolts may be loosen on the bike.
Inspect all bolts and tighten any loosen ones.
•
Frequently inspect all bolts, pedals and fittings on equipment to ensure they are secure.
safely
