Everglades 455 CC, Owner'S Manual

Page: 99 / 200

99
Fresh Water System
The cabin drain and shower sump system is located
in the forward bilge, below the cabin sole. It is
essential that the drain pump strainer is cleaned
regularly to remove accumulated debris that will
clog the shower drain system.
Fresh Water Washdown
Quick-release fresh water washdown hose
connectors are located on the side of the cockpit and
in the anchor winch compartment. Each connector
has an automatic valve that is always closed until
the washdown hose is connected. The hose requires
a special fitting that snaps into the connector and
activates the automatic valve. The cover on the
connector should always be closed to keep the
connector clean when the washdown hose is not
attached. Contact your dealer for information on
replacement fittings and hoses.
Make sure the Fresh Water switch is on before using
the washdown hose.
7.3 Water Heater
The water heater is located in forward bilge and
accessed through a hinged door in the rear shower
bulkhead. The 120 volt AC element that heats the
water is thermostatically controlled at the heater and
activated by a circuit breaker located in the AC panel.
A high pressure relief valve protects the system from
excessive pressure. To avoid damage to the water
heater, always make sure all air is purged from the
water heater and lines before activating the water
heater breaker. Refer to the water heater owner’s
manual for additional information.
CAUTION
DO NOT SUPPLY CURRENT TO AN EMPTY WATER HEATER.
DAMAGE TO THE HEATER WILL RESULT. THE SYSTEM MUST
BE FILLED AND PRIMED BEFORE USING THE WATER HEATER.
7.4 Fresh Water System Maintenance
Information supplied with water system components
by the equipment manufacturers is included with
this manual. Refer to this information for additional
operation and service data.
Routine Maintenance
The following items should be done routinely to
maintain your fresh water system:
Typical Fresh Water Washdown Quick Connection
Fresh Water Pump & Strainer
• Periodically remove and clean the water strainer
located near the intake side of the fresh water
pump. To clean the strainer, make sure the Fresh
Water pump switch is off. Rotate the strainer
bowl counterclockwise to release it. Remove and
clean the screen with fresh water. Lubricate the
O-ring lightly with Teflon or silicone grease and
reinstall the strainer bowl.