Value IP 2MP 288 Series / 3MP 368 Series
15
Rotational Adjustment:
Loosen the rotate screw and rotate the camera left / right to the desired
position, then tighten the rotate screw. Due to the internal connector design, it is recommended
not to rotate the camera more than 30°.
30°
30°
Rotation screw
Tilt Adjustment:
Loosen the two tilt screws and adjust the angle by 75° to the desired position, then
tighten the tilt screw.
75°
Tilt screw
8.
Secure the cover back to the camera.
EZN288/368
&
EZN288/368M
1.
Before screwing the camera to the wall, stick the
Sticker
on the wall / ceiling to mark the position
for installation. Drill three (
EZN288/368
) or four (
EZN288/368M
) holes on the wall / ceiling
according to the supplied
Sticker
and push the supplied
Anchors
into the three holes on the wall /
ceiling. Drill another hole in the middle of the
Sticker
if you wish to run the wires into the wall /
ceiling.
EZN288/368
EZN288/368M
