Installation (continued)
15
4. Disconnect
after use
AFTER
EACH
USE,
disconnect power to the pump
using the following
procedure:
a)
Disconnect the vehicle battery ground wire.
b)
Disconnect the pump clamp with
black
wire from the
negative (-)
terminal of the battery.
c)
Disconnect the pump clamp with
red
wire from the
positive (+)
terminal of the battery.
d)
Reconnect the vehicle battery ground wire.
Note:
Skip steps (a) and (d) if battery is not in a vehicle.
WARNING:
Always disconnect in this sequence to avoid possible shock.
NOTE: It is important to disconnect power to the pump when not in use for
safety reasons. ALWAYS verify that the power has been disconnected
before adding chemicals or servicing.
Step Four: Check and test completed assembly.
WARNING
Check and test completed assembly
Serious injury could result from chemical leaks if pump is improperly assembled or the design
of the pump is modified.
Follow the steps below to ensure the pump is properly assembled. Never modify the pump
design.
1. Check
assembly
Check assembly to assure the pump is properly assembled and in safe
working condition:
2. Before
starting the
pump
a) Test the system for leaks with water
b) Ensure water supply is adequate. Do not run dry.
c) Check inlet strainer for debris.
d) Verify hoses are in good condition and all connections are tight.