Everbilt PCP10001-VSP, Use And Care Manual

Page: 12 / 36

Program the Operation Schedule
Set the Current Time

Press the MENU button and hold it.
> HOURS will start to flash.

Stop pressing MENU.

Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.
> MINUTES will start to flash.

Press the UP or DOWN arrows to Adjust Minutes.

Press the ENTER button.
> Control Panel will display Period 1 settings.
PERIOD 1
STEP 1 -
START time:

Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.

Press the UP or DOWN arrows to Adjust Minutes.
STEP 2 - END time:
Press ENTER button once.

Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.

Press the UP or DOWN arrows to Adjust Minutes.
STEP 3 - Operating Speed: Press ENTER button once

Press either LOW, MEDIUM or HIGH.

Adjust the Operating Speed in 25 RPM increments by
pressing the UP or DOWN Arrows.
STEP 4 – Press the ENTER button once, the Control Panel will display
Period 2 settings.
PERIOD 2
STEP 1 - START time:

Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.

Press the UP or DOWN arrows to Adjust Minutes.
STEP 2 - END time: Press ENTER button once.

Press the UP or DOWN arrows to Adjust Hours.

Press the ENTER button once.

Press the UP or DOWN arrows to Adjust Minutes.
STEP 3 - Operating Speed: Press ENTER button once.

Press either LOW, MEDIUM or HIGH.

Adjust the Operating Speed in 25 RPM increments by
pressing the UP or DOWN Arrows.
STEP 4 – Press the ENTER button once, the Control Panel will display
Period 3 settings.

If you are only setting Periods 1 and 2, wait 7 to 10
seconds and the new settings will be saved.

Then skip to the directions on the following page for “Start
Automatic Mode. ”
PERIOD 3
If you want to set Period 3, and the display shows “3 / OFF” , you need to enable Period 3 by pressing the UP arrow once.
NOTICE
:
To turn Period 3 OFF again, press either the UP or DOWN Arrow during STEP 1 (when HOURS is flashing) until the display shows “3/OFF”.