14
Please note that the discharge current is set automatically
depending on selected charge current:
0.25A discharge current is applied when 0.25A or 0.50A
charge current is selected,
0.50A discharge current is applied when 0.75A or 1A
charge current is selected.
Test mode
– can be used to test rated capacity of inserted
batteries. This is a single charge->discharge->charge cycle.
At the end of the process measured cell capacity (from
the discharge stage) can be read from LCD display. This
should be close to the battery’s rated capacity declared by
the manufacturer.
Please take note that new rechargeables may need few
charge/discharge cycles to reach their maximum capacity.
Batteries with much lower results than declared should
not be used. For the best results and performance it is
recommended to use the “everActive” rechargeables.
Please note that the discharge current is set automatically
depending on selected charge current – 0.25A discharge
current is applied when 0.25A or 0.50A charge current is
selected or 0.50A discharge current is applied when 0.75A
or 1A charge current is selected.
Summary of Contents for NC 1000M
Page 2: ...2...
Page 39: ...39 Notes Notizen Notatki...
