18
19
1. Secure the convenience base to the
vehicle seat.
a
Convenience base is securely installed with lower
anchor connector assembly system (shown)
(p. 20).
OR
a
Convenience base is securely installed with
vehicle seat belt (p. 22).
IMPORTANT:
A properly secured convenience base
does
NOT
move more than 25 mm (1 inch) from side-
to-side or from front-to-back
at the lower anchor
connector harness/vehicle belt path
.
a
Locking clip is installed, if necessary (p. 38).
a
Convenience base is adjusted so that level line is
level with ground (p. 24).
a
If necessary, a towel/small blanket is rolled up
and placed beneath the front edge of the base
for additional leveling (p. 24).
2. Secure the child in the child carrier.
a
Harness straps
MUST
start as close as possible to,
but
NEVER
above, the child’s shoulders (p. 34).
a
Both buckle tongues are fastened (p. 32).
a
Chest clip is securely fastened and at armpit
level (p. 32).
a
Harness straps are snug against the child and you
should not be able to pinch the harness (p. 32).
a
Crotch strap is snug against the child but
NOT
under the child’s bottom (p. 36).
3. Check your work.
a
The convenience base does
NOT
move more
than 25 mm (1 inch) from side-to-side or from
front-to-back
at the lower anchor connector
harness/vehicle belt path
.
a
The handle is in
Position 1
(Canadian
OR
U.S.
models) or
Position 4
(U.S. models
ONLY
) (p. 25).
(
Position 4
shown at left.)
Child’s head
MUST
be at least 25mm (1 inch) below
the top of the carrier.
Proper Installation WITH
the Convenience Base
Child Requirements
Weight:
2.3 to 10 kg (5 to 22 lbs)
Height:
48 to 74 cm (19 to 29 inches)
Top of the child’s head must be
at least
25 mm
(1 inch) below the top of the child restraint seat back.
Harness straps at, or
below, the shoulder.
At least 25 mm
(1 inch)
Lower anchor connector assembly
Harness/Vehicle Seat Belt
WARNING
To make installation
easier, watch the
installation video of this
child restraint at www.
evenflo.com.
T
IP
!
T
IP
!
